Rotary clothes line

Discussion in 'Garden Projects and DIY' started by stumorphmac, Oct 23, 2022.

  1. stumorphmac

    stumorphmac cymbidist

    Joined:
    Dec 8, 2010
    Messages:
    337
    Gender:
    Male
    Occupation:
    RETIRED GARDENER
    Location:
    Powys
    Ratings:
    +212
    Not sure if this is the right place
    Installing a rotary clothes line which I have done before installing is not the problem,ground spike is.
    How can I stop it filling with water even with a plastic cap it still fills and eventually rots the bottom post of the washing line and not always possible to remove it each time it's used.
    Did think of drilling a hole at the base to let water out but then it's encased in concrete
    Any suggestions would be good
     
  2. pete

    pete Growing a bit of this and a bit of that....

    Joined:
    Jan 9, 2005
    Messages:
    51,027
    Gender:
    Male
    Occupation:
    Retired
    Location:
    Mid Kent
    Ratings:
    +93,703
    You would need a long masonry bit and drill through the concrete.
    Any idea how deep you went with the hole?
     
  3. stumorphmac

    stumorphmac cymbidist

    Joined:
    Dec 8, 2010
    Messages:
    337
    Gender:
    Male
    Occupation:
    RETIRED GARDENER
    Location:
    Powys
    Ratings:
    +212
    It's not got concrete at the moment the old concrete has been removed leaving a empty hole ready for the new ground spike to go in
    The new line has larger diameter poles so whole thing needs replacing
    So was wondering what to do before it all gets concreted again
     
  4. pete

    pete Growing a bit of this and a bit of that....

    Joined:
    Jan 9, 2005
    Messages:
    51,027
    Gender:
    Male
    Occupation:
    Retired
    Location:
    Mid Kent
    Ratings:
    +93,703
    Ok.
    So I'm guessing you will be putting concrete all around and below the new spike.
    Guessing that the spike is one of those with the bottom all crushed up so you can drive it into the ground.
     
  5. JWK

    JWK Gardener Staff Member

    Joined:
    Jun 3, 2008
    Messages:
    32,365
    Gender:
    Male
    Location:
    Surrey
    Ratings:
    +49,749
    Does it matter if it gets water in? The poles are aluminium, I thought, so they shouldn't rot or rust.
     
  6. pete

    pete Growing a bit of this and a bit of that....

    Joined:
    Jan 9, 2005
    Messages:
    51,027
    Gender:
    Male
    Occupation:
    Retired
    Location:
    Mid Kent
    Ratings:
    +93,703
    Some might be some are steel, or they used to be, not sure what they use now.
     
  7. stumorphmac

    stumorphmac cymbidist

    Joined:
    Dec 8, 2010
    Messages:
    337
    Gender:
    Male
    Occupation:
    RETIRED GARDENER
    Location:
    Powys
    Ratings:
    +212
    Correct
     
  8. pete

    pete Growing a bit of this and a bit of that....

    Joined:
    Jan 9, 2005
    Messages:
    51,027
    Gender:
    Male
    Occupation:
    Retired
    Location:
    Mid Kent
    Ratings:
    +93,703
    Can you cut the crushed bit off and then set it in concrete with a piece of reinforcing bar pushed down the middle, remove the rebar before the concrete is fully set, should leve a drainage hole down the middle.
     
    • Agree Agree x 1
    • noisette47

      noisette47 Total Gardener

      Joined:
      Jan 25, 2013
      Messages:
      6,446
      Gender:
      Female
      Location:
      Lot-et-Garonne, Aquitaine
      Ratings:
      +15,722
    • Sheal

      Sheal Total Gardener

      Joined:
      Feb 2, 2011
      Messages:
      36,097
      Gender:
      Female
      Location:
      Dingwall, Ross-shire
      Ratings:
      +54,253
      Is it the concrete that's holding the water in? I've not had a problem with any water retention down the years but the spikes have never been concreted in.
       
    • stumorphmac

      stumorphmac cymbidist

      Joined:
      Dec 8, 2010
      Messages:
      337
      Gender:
      Male
      Occupation:
      RETIRED GARDENER
      Location:
      Powys
      Ratings:
      +212
      It could well be the concrete but without where I live a gust of wind and it tips over
       
      • Informative Informative x 1
      • JWK

        JWK Gardener Staff Member

        Joined:
        Jun 3, 2008
        Messages:
        32,365
        Gender:
        Male
        Location:
        Surrey
        Ratings:
        +49,749
        How about making a foot deep hole beneath where the pole sits in the ground. It doesn't need to be wide, then fill with gravel to make a simple soak away. The concrete needs to go at the sides rather than underneath to avoid making a sump.
         
        • Agree Agree x 2
        • Like Like x 1
        • Sheal

          Sheal Total Gardener

          Joined:
          Feb 2, 2011
          Messages:
          36,097
          Gender:
          Female
          Location:
          Dingwall, Ross-shire
          Ratings:
          +54,253
          I live on high exposed ground and don't have a problem with mine staying upright. The secret I've found is to hang the washing evenly round the lines. Not only length of items but their weight.
           
          • Like Like x 1
          • Informative Informative x 1
          • stumorphmac

            stumorphmac cymbidist

            Joined:
            Dec 8, 2010
            Messages:
            337
            Gender:
            Male
            Occupation:
            RETIRED GARDENER
            Location:
            Powys
            Ratings:
            +212
            We live where the soil is wet sits on top of clay
             
            • Informative Informative x 1
            Loading...

            Share This Page

            1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
              By continuing to use this site, you are consenting to our use of cookies.
              Dismiss Notice