setting up the carb on a 2 stroke petrol strimmer?

Discussion in 'Tools And Equipment' started by robgil, Aug 30, 2010.

  1. robgil

    robgil Gardener

    Joined:
    Jun 23, 2010
    Messages:
    112
    Ratings:
    +5
    ok guys , its a McCullough mt300x , it has three adjustment screws , one for air , one for idle and one for high speed.
    i have put both air and high speed adjustment screws in full then out 1 1/2 turns then started it.
    i got the idle spot on but i cannot get the high speed to work , at first it would cut out when i gave it any throttle then i got to the stage where it would rev ok until under load, then it would cut out again (as soon as i tried to strim something). , this is where i am now with it.
    any ideas?
     
  2. Marley Farley

    Marley Farley Affable Admin! Staff Member

    Joined:
    May 11, 2005
    Messages:
    30,588
    Occupation:
    Grandmother Gardener Councillor Homemaker
    Location:
    Under the Edge Zone 8b
    Ratings:
    +14,127
    Hi Rob I asked my SiL & he spoke to someone who has one & this is what he sent me back.. If this doesn't work he thinks if you fine tune around those settings you will get it.. :gnthb: Hope so..
     
  3. daitheplant

    daitheplant Total Gardener

    Joined:
    Dec 19, 2006
    Messages:
    10,282
    Gender:
    Male
    Occupation:
    Retired
    Location:
    South East Wales
    Ratings:
    +2,881
    Rob, it should have been factory set so why did you need to reset it?:wink::gnthb:
     
  4. robgil

    robgil Gardener

    Joined:
    Jun 23, 2010
    Messages:
    112
    Ratings:
    +5
    thanks Marley, i shall give that a whirl.
    daitheplant it was a freebee that was given to me , the previous owner had a fiddle with the carb i think but couldn't get it to run then i had a fiddle as well, turned out the exhaust was all blocked up. :doh:
     
  5. daitheplant

    daitheplant Total Gardener

    Joined:
    Dec 19, 2006
    Messages:
    10,282
    Gender:
    Male
    Occupation:
    Retired
    Location:
    South East Wales
    Ratings:
    +2,881
    Enough said Rob, is it running ok now?:gnthb:
     
  6. Marley Farley

    Marley Farley Affable Admin! Staff Member

    Joined:
    May 11, 2005
    Messages:
    30,588
    Occupation:
    Grandmother Gardener Councillor Homemaker
    Location:
    Under the Edge Zone 8b
    Ratings:
    +14,127
    :wink: Well I am hoping so Dai, as we haven't heard from him... :wink::lollol:
     
  7. daitheplant

    daitheplant Total Gardener

    Joined:
    Dec 19, 2006
    Messages:
    10,282
    Gender:
    Male
    Occupation:
    Retired
    Location:
    South East Wales
    Ratings:
    +2,881
    He has probably got it running and is now tring to sell it on eeebayyy.lol
     
  8. Marley Farley

    Marley Farley Affable Admin! Staff Member

    Joined:
    May 11, 2005
    Messages:
    30,588
    Occupation:
    Grandmother Gardener Councillor Homemaker
    Location:
    Under the Edge Zone 8b
    Ratings:
    +14,127
    :rotfl: Aww Dai.... :rotfl::rotfl:
     
Loading...

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice